Multiple Choice Questions (MCQ) on Automobile Engineering

Multiple Choice Questions (MCQ) on Automobile Engineering

 

The following components forms valve operating mechanism except

  1. Push rod
  2. Rocker arm
  3. Valve seat
  4. Fork

(Ans:d)

 

Which of the following is true?

  1. high torque is required at the start of the vehicle
  2. low torque is required at high speeds
  3. gearbox helps in smooth running of vehicle
  4. all of the above

(Ans:d)

 

Which of the following is not a type of gearbox?

  1. Linear mesh gearbox
  2. Sliding mesh gearbox
  3. Constant mesh gearbox
  4. Synchromesh gearbox

(Ans:a)

 

Overdrive is placed

  1. before gearbox
  2. in between propeller shaft and gear box
  3. after propeller shaft
  4. in between engine and gear box

(Ans:b)

 

A machine member used to connect engine shaft to gear box is called

  1. differential
  2. clutch
  3. flywheel
  4. propeller shaft

(Ans:b)

 

The overdrive consists of ______ gear train.

  1. simple
  2. compound
  3. Epicyclic
  4. Reverted

(Ans:c)

 

The clutch plate is hold in between ______ and pressure plate.

  1. flywheel
  2. gear box
  3. engine
  4. crankshaft

(Ans:a)

 

Which type of clutch does not require clutch pedal?

  1. Single plate
  2. Multi plate
  3. Centrifugal
  4. Cone

(Ans:c)

 

Which device used for transmitting increased or decreased power from one shaft to another?

  1. Hydraulic torque converter
  2. Propeller shaft
  3. Differential
  4. Crankshaft

(Ans:a)

 

The amount of tilt measured in degrees from the vertical, is called

  1. camber angle
  2. caster angle
  3. toe-in
  4. toe-out

(Ans:a)

 

Camber should not exceed

  1. 2 degrees
  2. 4 degrees
  3. 6 degrees
  4. 8 degrees

(Ans:a)

 

The angle between the king-pin centre line and the vertical, in the plane of the wheel is called

  1. Caster angle.
  2. Camber angle
  3. King pin inclination
  4. Toe-out

(Ans:a)

 

The purpose of caster is to give a trailing effect to the

  1. front wheels
  2. rear wheels
  3. inner wheels
  4. outer wheels

(Ans:a)

 

The differential unit consists

  1. one bevel pinion
  2. two bevel pinion
  3. three bevel pinion
  4. four bevel pinion

(Ans:b)

 

Four-wheel drive vehicles have differential at

  1. front wheels
  2. rear wheels
  3. both the front and rear wheels
  4. any of the front or rear wheels

(Ans:c)

 

The propeller shaft consist of

  1. knuckle joint
  2. flange coupling
  3. universal joint
  4. Rag joint

(Ans:c)