Automobile Engineering MCQs
1- The clutch is placed between the
(A) Fly wheel and gear box
(B) Crankshaft and flywheel
(C) Propeller shaft and Differential
(D) Gear box and propeller shaft
2- Clutch slippage is noticeable particularly
(A) during braking
(B) during acceleration
(C) during gear change
(D) during idling
3- Floor board clearance is the difference between
(A) throw out bearing and release lever
(B) pedal and floor board
(C) clutch plate and pressure plate
(D) none of the above
4- In cone clutch, the cone angle commonly used are
(A) 40 to 60 degrees
(B) 20 to 30 degrees
(C) 12 to 16 degrees
(D) 1 to 2 degrees
5- When two shafts neither parallel nor intersecting, power can be transmitted using
(A) Spiral gears
(B) Oldham’s coupling
(C) Helical gears
(D) Spur gears
6- In the case of an automobile having four wheel drive
(A) Fuel consumption decreases
(B) The road adhesion decreases
(C) The road adhesion increases
(D) Clutch linkage are simple
7- The only prominent defect that usually occurs in the frame due to accidents is the
(A) Shear of nut and bolt
(B) Alignment fault
(C) Welding failure
(D) None of the above
8- The shaft which transmit the drive from the transmission to the bevel pinion is known as
(A) Main shaft
(B) Lay shaft
(C) Propeller shaft
(D) Clutch shaft
9- Sulphur content in the diesel fuel is limited to
(A) 5%
(B) 2%
(C) 1%
(D) 0.5%
10- The basic purpose of the universal joint in drive line is
(A) Drive shaft to be removed and installed easily
(B) Drive shaft length to change
(C) Drive shaft to be supported at centre
(D) Drive angle change
ANSWERS:
1-(A), 2-(B), 3-(B), 4-(C), 5-(C), 6-(C), 7-(B), 8-(C), 9-(D), 10-(B)