Multiple Choice Questions (MCQ) on Automobile Engineering, Objective type questions on Automobile Engineering
Automobile Engineering Objective Questions and Answers 1- The device for smoothening out the power impulses from the engine is called – (A) Clutch (B) Differential (C) Flywheel (D) Torque Converter 2- The coefficient of friction for the clutch facing is approximately – (A) 0.1 (B) 0.4 (C) 0.8 (D) 1.2 3- Flash fire […]
Read MoreMultiple Choice Questions on Automobile Engineering 1- Which is more common lubrication system used in 4 stroke IC engine? (A) wet sump lubrication (B) dry sump lubrication (C) mist lubrication (D) none of the above 2- Diesel cycle is known as (A) constant volume cycle (B) constant temperature cycle (C) constant pressure cycle (D) […]
Read MoreMCQ on Internal Combustion (IC) Engines 1- The compression rings of piston are made of (A) Aluminum alloy (B) Cast iron (C) Steel (D) Brass 2- The actual power developed inside an engine cylinder is called (A) Total power (B) Brake power (C) Indicated power (D) Horse power 3- The lower portion of […]
Read MoreAutomobile Engineering MCQ Questions and Answers 1- Following method is used to determine the indicated power of a multi-cylinder SI engine (A) Heat balance test (B) Prony brake test (C) Morse test (D) All of the above 2- Higher value of octane number of fuel indicates (A) longer ignition delay (B) low volatility (C) […]
Read MoreAutomobile Engineering MCQ Quiz 1- The system governing the angular movement of front wheels of a tractor is called (A) Steering system (B) Rotating system (C) Dragging system (D) Differential system 2- It is the point on the tractor body at which its weight may be considered as acting (A) Weighing (B) Suspension (C) […]
Read MoreInternal Combustion Engines – Questions and Answers 1- In four stroke engine, one working cycle is completed by ___ revolutions of crankshaft (A) 1 (B) 2 (C) 3 (D) 4 2- In diesel, scavenging means (A) removal of combustion products from an internal combustion engine cylinder on the return stroke of the piston (B) […]
Read MoreAutomobile Engineering Multiple Choice Questions 1-The process in which hydrocarbons and decomposed into smaller hydrocarbons is called (A) Isomerization (B) Evaporation (C) Cracking (D) Reforming 2-Four strokes of an IC engine need ___ degrees of Crank rotation. (A) 180° (B) 360° (C) 540° (D) 720° 3-The method of governing used in petrol engines […]
Read MoreMCQ Questions on Automobile Engineering 1-The most important characteristic of lubricants in automobiles is the (A) viscosity (B) physical stability (C) chemical stability (D) resistance against corrosion 2-Which of the following is mounted between the engine and gear box? (A) propeller shaft (B) differential gear (C) flat belt drive (D) Clutch 3-In case […]
Read MoreMCQ on Steering System of an Automobile 1-The steering system gives the vehicle ___ . (A) directional stability (B) stable power (C) wheel alignment (D) all of the above 2-For a proper steering system, each of the wheels must follow ________ . (A) same turning circle (B) different turning circle (C) straight line […]
Read MoreInternal Combustion (IC) Engines MCQ Questions and Answers 1-The preference of diesel engines for road transport is due to (A) harmless exhaust (B) complete combustion of charge (C) low specific fuel consumption over a large range of load (D) Easy starting 2-The air–fuel ratio for idling speed of an automobile petrol engine is closer […]
Read More