Objective Questions and Answers on Automobile Engineering. Multiple Choice Questions (MCQ) with answers on Automobile Engineering.
1- The main function of the clutch is to temporarily disconnect the engine from the
(A) Propeller shaft
(B) Differential
(C) Overdrive
(D) Gearbox
2- The engine component for smoothening out the power impulse particularly in four stroke engine is
(A) Flywheel
(B) Crankshaft
(C) Clutch
(D) Gearbox
3- The clutch pressure plate is bolted to the
(A) Clutch cover
(B) Flywheel
(C) Camshaft
(D) Crankshaft
4- The type of clutch mostly used in two wheeler in India
(A) Single disc dry
(B) Single disc wet
(C) Multi disc dry
(D) Multi disc wet
5- The combination of crown wheel and pinion is called
(A) Rear drive
(B) Final drive
(C) Rear axle
(D) Differential
6- The torsion springs are provided on the clutch plate in order to
(A) Provide the friction lining on them
(B) Take the axial load
(C) Engage the clutch smoothly without any chattering
(D) Dampen the torsional vibration
7- The cooling of engine is simple when the engine is mounted at the
(A) Front of the vehicle
(B) Left side of rear axle
(C) Centre of the vehicle
(D) Centre of rear axle
8- In automatic transmission the torque multiplication is achieved through
(A) Synchromesh gear box
(B) Free wheel unit
(C) Torque converter
(D) Fluid coupling
9- The gear box oil has to do
(A) To cool gear box
(B) To reduce friction and power loss
(C) To lubricate all moving parts and prevent wear
(D) All of the above
10- Most of the propeller shafts have following two types of joints.
(A) U joints and universal joint
(B) Transmission and differentials
(C) Slip joints and spines
(D) Universal and slip joints
11- Hot spark plug has a
(A) Long insulator
(B) Heat dam
(C) Long heat path
(D) Short heat path
12- The centre portion of typical universal joint is called the
(A) Spider
(B) Bearing
(C) Joint
(D) Transunion
13- The governor is driven by
(A) the transmission output shaft
(B) the engine crankshaft
(C) the transmission input shaft
(D) the stator
14- The tandem type master cylinder has
(A) Four piston
(B) Three piston
(C) Two piston
(D) One piston
ANSWERS:
1-(D), 2-(A), 3-(B), 4-(D), 5-(A), 6-(D), 7-(A), 8-(D), 9-(D), 10-(D), 11-(A), 12-(A), 13-(B), 14-(C)