Questions and Answers on Automobile Engineering

Automobile Engineering MCQ on Automobile Engineering

51- It is a small filtering device used to remove water from the diesel fuel before it reaches the sensitive parts of the diesel engine         

A:- Diesel fuel water separator         

B:- Diesel fuel feed pump         

C:- Diesel injection pump         

D:- Engine gasket           

 

52- MAP sensors measure the         

A:- Exhaust manifold pressure         

B:- Intake manifold pressure         

C:- Stroke volume pressure         

D:- Compression pressure         

 

53- The malfunction indicator lamp in an EFI system, also known as         

A:- Check engine lamp         

B:- Pilot lamp         

C:- Effective lamp         

D:- Dipper lamp         

 

54- Which of the following causes is low oil pressure in an engine?         

A:- Stainer pipe mounting loose         

B:- High oil viscosity         

C:- Piston ring worn out         

D:- High oil level         

 

55- What is the result of a defective fuel feed pump in an engine?         

A:- Engine noise         

B:- Low oil pressure         

C:- Low power generation         

D:- Engine overheating         

 

56- Tyre’s inner edge will wear out faster due to         

A:- Positive caster         

B:- Negative caster         

C:- Positive camber         

D:- Negative camber         

 

57- Which of the following gears produced axial thrust while transmitting torque?         

A:- Spur gear         

B:- Helical gear         

C:- Rack and pinion         

D:- All of these         

 

58- In these types of wheel cylinders, both brake shoes become the leading shoe in the forward direction         

A:- Single piston wheel cylinder         

B:- Double piston with straight bore         

C:- Double piston with step bore         

D:- Baffle-type piston wheel cylinder         

 

59- This is intended to damp torsional vibrations of the crankshaft generated by the periodic cycles of the engine         

A:- Flywheel         

B:- Fluid coupling         

C:- Dual mass flywheel         

D:- Cone clutch         

 

60- It is provided in the torsion bar suspension system to adjust the height of the lower control arm         

A:- Bar adjuster         

B:- Eye bolt adjuster         

C:- Wishbone adjuster         

D:- None of these           

 

ANSWERS:

51-(A), 52-(B), 53-(A), 54-(C), 55-(C), 56-(D), 57-(B), 58-(A), 59-(C), 60-(B)